|
Message
From: Rudolf Usselmann <rudi@a...>
Date: 03 Jun 2003 16:05:28 +0700
Subject: Re: [usb] USB1.1 Core Address Assignment Failing. Debuggingsuggestions?
Make sure that the clock is really 48 Mhz, check it carefully,
should have less than 0.25% (?) jitter - check the usb spec, I
might be off here ...
Most common mistake is setting the tx_mode incorrectly in the
usb_phy. Second most common mistake is ROM contents. The default
should get you enumerated on a linux box. Even though it's useless
without a custom driver ...
Function address 0 seems to be strange. Never have seen that ...
On a linux box, install the usb tools, may be you already have
the "lsusb" command, see what that reports.
Good luck,
rudi
-------------------------------------------------------
www.asics.ws -- Solutions for your ASIC/FPGA needs ---
---------------- FPGAs * Full Custom ICs * IP Cores ---
* * * FREE IP Cores --> http://www.asics.ws/ <-- * * *
|
 |
Browse
