Message

Reply | Reply all

Date Prev | Date Next | Thread Prev | Thread Next Date Index | Thread Index

From: adimbox-uclinux at yahoo.com.br<adimbox-uclinux@y...>
Date: Thu Jun 30 21:25:02 CEST 2005
Subject: [openrisc] or1k and altera
Hello there.

I was searching for a core that run uClinux (or other linux with
MMUless support) for an University project, and Damjan Lampret pointed
this project to me.

I'm very new at FPGA world, so I have some newbe questions, sorry :)

I looked throw Overview page, but there are no docs on how to use
OpenRisc1000. I use - better yet, I have and intend to use - an Altera
FGPA.

How can I try to make it work in such board ? How to upload the core
and uClinux to it, which software to use ? Quartus ? To which port ?
Byteblaster II or MV or what ? And how to test it after all is done ?

Or if or1k doesn't work in Altera's board, do you know any other core
in OpenCores which can, with linux support ?

I have more questions, but that is for later !

Thanks a lot.