OPENCORES.ORG

I assume you just want to be able to use GDB to debug code running on

Thanks Jeremy for the reply, but actually i am using a board from Xilinx 
that doesn't contain any free GPIOs, so this is way i am looking for a 
solution to configure the FPGA and download the code on the OR1200 from 
the same JTAG interface.

Jeremy Fillingim wrote:

>I assume you just want to be able to use GDB to debug code running on
>your OR1200.
>
>You don't need to link the OR1200 JTAG interface to the FPGA JTAG
>interface. Just route the JTAG pins from the OR1200 out to available
>GPIOs and connect your JTAG cable to those pins.
>
>This works very well for debugging code.
>
>I can think of a way to put the OR1200 JTAG and the FPGA JTAG in a
>single loop, but it doesn't seem very useful since you'd lose the
>ability to configure the FPGA via JTAG.
>
>On 5/17/05, Amr El Dieb <amr@s...> wrote:
>  
>
>>I am trying to implement the OR1200 microprocessor on Virtex II FPGA,
>>and i want to link the local JTAG interface of the OR1200  (debug port)
>>to the external JTAG interface of the FPGA. So, i want to ask if this is
>>possible or not? and if it is possible, how i can do it?
>>
>>Thanks in advance.
>>
>>_______________________________________________
>>http://www.opencores.org/mailman/listinfo/openrisc
>>
>>    
>>
>
>_______________________________________________
>http://www.opencores.org/mailman/listinfo/openrisc
>  
>