|
Message
From: zhoukl@s...
Date: Mon, 29 Sep 2003 09:13:24 +0200
Subject: Re: [openrisc] JTAG Proxy server
Thanks for your reply!
Maybe there is sth wrong with my or1200 debug interface and I shoud
simulate the debug interface with ncsim first.
And I notice that there is a dbg_if model in orp_soc. But to simulate
the debug interface , two file :gdb_in.dat and gdb_out.dat are needed.
I can't find them in the orp_soc. So how can I get these two files or get
around of them.
Thanks!
Zkl
----- Original Message -----
From: Marko Mlinar <markom@o... >
To: openrisc@o...
Date: Mon, 29 Sep 2003 08:28:45 +0200
Subject: Re: [openrisc] JTAG Proxy server
>
>
>
>
> No, you should have JTAG server connected correclty, and you will
> get complete
> message below. If there is something wrong with the connection, you
> will get
> only partial connection. You should run only ./jp1-xilinx for what
> are you
> trying to do.
>
> Marko
>
>
> On Sunday 28 September 2003 05:58, zhoukl@s... wrote:
> > Hi
> >
> > I've searched the forum for messages about JTAG Proxy
> server,
> >
> > and see the following message:
> > >When you start jtag server you have to get this messages:
> > >[root@njord jtag]# ./jp1-xess 9999
> > >Connected to parallel port at 378
> > >Dropping root privileges.
> > >JTAG Proxy server started on port 9999
> > >Press CTRL+c to exit.
> >
> > but when I run ./jp1-xilinx 9999, the only message is :
> > Connected to parallel port at 378
> > It seemed that the jtag proxy server has not started
> correctly.
> > Can the JTAG proxy server be running in RedHat 7.3
> without JTAG
> > connection to any board?
> > And when I run jp1-rtl_sim to connect jp1 to RTL
> simulation, it
> > report:Can not open ../sim/rtl_sim/run/gdb_in.dat. So how can
> I get
> > this file ?
> > Thanks
> > zkl
>
|
 |
Browse
