|
Message
From: Jim<jimyh@2...>
Date: Fri, 18 Apr 2003 12:52:35 -0100
Subject: Re: [openrisc]help about: Link Error
thank you all.
i made a mistake about the download.
when i download a new uclibc.tar.gz to overwrite the old one,
everything is ok.i find that the old package have some problems cause
by the download process.
And i know that, the uclibc install the libc.a file for the linker, after
install this package, the -lc error info is disappear.
----- Original Message -----
From: Jim<jimyh@s... >
To: openrisc@o...
Date: Thu, 17 Apr 2003 05:46:47 -0100
Subject: Re: [openrisc]help about: Link Error
>
>
> marko,
>
> i do what you adviced.
> i reinstall the tools step by step.
> binutils, gcc and gdb are installed with no error.
> i think, it is enough to compile a short program.
> but gcc give me the same err info:
> /ld: cannot find -lc
> i can find a libgcc.a file at the uclinux folder.
> so i do not know how to solve it.
>
> after that, i try to install the uclinux and uclibc, and also
> encounter an
> error.
> i install them step by step.
> when i "make " the uclibc , the error info show that:
> can not find the file or directory: include/bits/....
> i cannot find this "/bits/.." directory anywhere.
>
> i suppose, although i can't install the uclibc and uclinux, i can
> run gcc
> successful if the compiler installed successful.
> but NOT.
>
>
> yours, Jim
>
>
>
> ----- Original Message -----
> From: Marko Mlinar <markom@o... >
> To: openrisc@o...
> Date: Wed, 16 Apr 2003 08:00:44 +0200
> Subject: Re: [openrisc]help about: Link Error
>
> >
> >
> > apparently your gcc does not find libc.lib file, which should
> be in
> > the
> > reported dir.
> > There is a problem with your installation, but cannot figure
> out
> > what exactly
> > could be wrong. If you cannot figure it out, go through
> > installation
> > procedure again and be sure to do everything according to the
> > instructions.
> > You should have no problems then.
> >
> > best regards,
> > Marko
> >
> > On Tuesday 15 April 2003 20:09, Jim Yang wrote:
> > > hi,all:
> > > i have some problems when i try to compile the "hello
> world"
> > program.
> > > The err info :
> > >
> > >
> >
> /opt/or32-uclinux/lib/gcc-lib/or32-uclinux/3.1/../../../../or32-
> uclinux/bin
> > >/ld: cannot find -lc
> > > collect2: ld returned 1 exit status
> > >
> > > i think this err is cause by the linker. But i can not
> sure
> > it.
> > > Maybe someone can help me about it.
> > >
> > > thank you!
> > >
> > >
> > >
> > > Jim <jimyh@s... >
> >
>
|
 |
Browse
